XK8 Parts Review - XK8 / XKR Rear Suspension Layout

The rear suspension system of the Jaguar XK8 / XKR is generally working well in service. However, as the car ages, we are starting to hear of some problems with the CATS (Computer Active Technology Suspension) System cars and the interface with the electrical system not working possibly down to the shock absorber parts rotating and pulling off the connections.

Changing the rear shock absorbers can be difficult with the rear suspension having to be lowered and the required use of a slim spring compressor. The fulcrum pin holding the shock absorber in place may well have corroded and then needs to be cut off with an angle grinder.

However all can be resolved and we are pleased to announce that the rear suspension layout and the associated parts list can be reviewed and purchased via www.jaguarpartsdb.com

To view the XK8 and XKR Rear Suspension Parts Assembly, click HERE www.jaguarpartsdb.com

You may also be interested in our full Jaguar XK8 / XKR Parts Review relating to the common rear suspension problems. Click HERE.

Copywright - Jaguar XK8 and XKR Parts

XK8 / XKR Parts Review - Rear Suspension Set Up

Introduction

The Jaguar XK8 and XKR Rear Suspension system has generally worked well in service. The assembly and associated parts are based on the proven Jag X300 system which in turn was based on the older Jag XJ40 system. However problems are starting to present which the XK8 / XKR owner needs to be aware of.

CATS (Computer Active Technology Suspension) System

The introduction of the CATS system was based on the older X300 rear suspension design. CATS manages and optimises the ride and handling of the XK8 / XKR car by means of uprated springs to increase the stiffness and electronic adaptive dampers under electronic control. Sensors at the front and rear of the car monitor the road and handling conditions and alter the electronic dampers to soften or stiffen the dampers. On start up the springs default to a stiffer setting and then under way on a smooth road, will soften. The settings will change in micro settings as braking, cornering and road conditions affect the car.

XK8 / XKR Suspension Problems

If you have a car fitted with CATS and the rear suspension is not working effectively then this can be a problem with the electrical connections from the shock absorber going into the wiring loom. Over time, the shock absorbers can actually rotate in service which may cause the electrical connections to be pulled off. This may necessitate the replacement of the shock absorbers part.

As with some other areas of the XK8 / XKR, changing the rear shock absorber parts is not as easy as it may look. Firstly, the rear suspension needs to be unbolted and lowered several inches. A special thin spring compressor is required to allow the release of the shock absorber from the spring unit. With the spring suitably compressed, the fulcrum pin can be removed which may well have seized in position. If this is the case, due to the severe lack of space in the area and the bottom of the spring compressor obstructing, this will have to be cut off with a small angle grinder

Jaguar XK8 / XKR Parts Review - Fulcrum Pin to the right which may have to be cut off.

To complete the removal of the shock absorbers, the rear tie bar needs to be removed together with the A -Frame safety plate. Also you will need to remove the nuts holding the top plate of the shock absorber spring pan.

These are main problems reported to date.

To view the XK8 and XKR Rear Suspension Parts Assembly, click here www.jaguarpartsdb.com

You may also be interested in our Jaguar XK8 / XKR Parts Review relating to the common front suspension problems.

Copywright - Jaguar XK8 and XKR Parts